Table of Contents
Product List
- Zap-a-Gap
- 3M Scotch-Weld Instant Adhesive
- CA40
- SF100
- Gorilla Super Glue
- Krazy Glue
- Loctite Super Glue
- Flex Seal Super Glue
- Starbond
Please Note: “Accelerator” products are not recommended for use, as they require additional engineering controls and storage considerations.
Instruction
- Preparation:
- Safety first, follow and wear required PPE
- Set up in well ventilated area
- Ensure surface protection, cover surrounding area as needed
- Ensure surfaces to be bonded are clean and dry
- Application:
- Apply a small amount to one surface
- Press the surface together and hold for 10 – 30 seconds
- Finishing:
- Allow the glue to cure fully (24 hours for maximum strength)
- Clean up: Wipe-off any excess glue immediately with a damp cloth
Required Personal Protective Equipment (PPE)
- Eye Protection: Safety Glasses
- Skin Protection: Nitrile Gloves
Engineering Controls
- Ventilation: Ensure adequate ventilation to disperse fumes.
- Work Area: Designate a specific, clean area for super glue use to avoid contamination and accidental bonding of unintended items.
- Spill Containment: Use a non-stick surface or protective mat to contain any spills.
Please Note: The use of an “accelerator” requires that work take place in a spray booth to prevent inhalation and aspiration of the product.
Emergency Response
- Skin:
- Do not pull apart skin that is bonded
- Soak in warm soapy water
- Gently peel apart
- Eye: Flush eyes with warm water for at least 15 minutes and seek medical attention immediately.
- Inhalation: Move to fresh air, ensure good ventilation. Seek medical attention if symptoms persist.
- Ingestion: Do not induce vomit, contact poison control and seek medical attention immediately.
Storage
- Store product in a cool, dry place, away from direct sunlight and heat sources.
Please Note: The “accelerator” products used in combination with cyanoacrylate must be stored in yellow flammables cabinets.
Disposal
- Allow to harden and dispose in trash.
Other Notes
- Do not eat, drink, smoke, or vape when using this product. Wash thoroughly before eating or drinking.
- Never use near an open flame or possible ignition source.
- Consult the SDS and the manufacturer’s instructions of all products before use.