Solvent Cement

Instruction

1. Preparation:
   • Follow manufacturer’s instructions
   • Wear required PPE
   • Set up in a well-ventilated area (a spray booth)
   • Ensure surface protection: cover surrounding areas
   • Clean the surface area you plan to bond
2. Application:
   • Apply a small amount of solvent cement to one surface using the applicator
   • Quickly press the two surfaces together and hold for a few seconds
3. Curing:
   • Let the bond fully cure (up to 24 hours) for maximum strength

Product List

Required Personal Protective Equipment (PPE)

• Eye Protection: Chemical Splash Goggles or Face Shield
• Skin Protection: Nitrile Gloves

Engineering Controls

• Use in a well-ventilated area (spray booth)
• Use in area where a safety eyewash and shower are nearby (Project Room, Gund L31)
• Use in area where a spill kit is nearby (Project Room, Gund L31)

Emergency Response

• Skin Contact: Wash with soap and water. Seek medical attention if irritation persists
• Eye Contact: Flush with water for 15 minutes. Seek immediate medical attention
• Inhalation: Move to fresh air, and seek medical attention if symptoms occur
• Ingestion: Do not induce vomiting, rinse mouth, seek immediate medical attention

Storage

• Store in a cool, dry place
• Keep the container tightly closed
• Store away from heat, sparks, and open flame, in a yellow Flammables Cabinet

Disposal

• Dispose of hardened cement (no longer liquid) in the landfill waste bin
• Consult Lab staff to determine local hazardous waste disposal requirements for unused product